Spectravision PLS600 Manual De Instrucciones página 7

,0,123(BC%;"(:(2'$;<..<;%&'(=(%'$;#>?;%&'(@<'><.
Models Power
PLW600 65W
PLW1200 100W
PLW2400 200W
* Specified at maximum 33°C water temperature
Completely water proof, IPx8 protection level
Thickness: only 21mm
Powered by separate power box PLX1200 over 2-wire 4 meter rubber cable
Bulb life of 30.000 hours
Installation:
Can be installed in any 1,5" water inlet
Precautions:
ALWAYS use with PLX1200 power box, NEVER with transformer
Maximum allowable water temperature: 33°C
Never to be used outside the water
Instructions and use:
The SPECTRAVISION light is a high technology electronic controlled light based on
white powerLED's creating a natural white color in the swimming pool.
The warranty of this product will be void when instructions for use and
installation are not followed correctly. No warranty when the lights are used
outside the water.
Electrical connections:
ATTENTION: reversing the polarity of the output power or
not following the color scheme of the wiring of the light,
can result in serious damage to the light and will void warranty.
!
Lumen * # LED's Dimensions
2016 lm 16 12 cm ∅
4032 lm 24
21 cm ∅
8064 lm 48 21 cm ∅
(
Electrical connection of transformer to PLX1200 power box (Fig. 6):
The PLX1200 connects to the 26V power output of the power box.
Connect the RED wire to the +26V terminal and the BLACK wire to GND terminal.
The PLX1200 has two separate outputs for ADAGIO lights. Each of these outputs
can be connected to a PLW600 or a PLW1200 light (Fig. 6).
Each output has 4 different screw terminals to connect the ADAGIO light:
the BLUE wire of the ADAGIO light has to be connected to the B terminal
•
the BROWN wire of the ADAGIO light has to be connected to the COM terminal
•
The R G and B terminals need to be bridged together
•
Only one single PLW2400 can be connected to this power box (Fig 7). In
this case, the terminals of both outputs need to be connected in parallel:
<R with R> <G with G>
as indicated on the board
Always check the DIP switch settings (Fig. 3) BEFORE turning on the
power to avoid damaging the light and to void warranty.
Remote control PLXREM (Fig.4)
An optional remote control is available. It consist of two handheld controllers,
a radio module, an external antenna and 10 meter extension cable.
This module has to be plugged in the upper connector (see arrow).
The handheld controller has 4 buttons:
an ON/OFF button to turn the lights ON or OFF
the arrow buttons control the light intensity of the white ADAGIO
the WHITE button is not used for white ADAGIO
The antenna cable needs to be plugged into the RF connector on the module.
Install the antenna outside (the technical room) to improve signal reception.
Synchronizing two or more PLX1200 power boxes (Fig. 5)
Synchronization of multiple lights (or multiple power boxes) is obtained by connecting
the AB terminals between the different boxes: < A with A> and <B with B>
<B with B> <COM with COM>
.
Straps are included.
,0,123( A!