VISIOMED bewell connect MyGluco BW-GL1 Manual De Instrucciones página 11

ENTERING THE SETTING MODE (A)
Start with the meter off (no test strip inserted). Press S.
1. Setting the date
The sequence of the date setting is: YEAR -> MONTH -> DAY. With the YEAR / MONTH
/ DAY flashing in sequence, press UP or DOWN until the correct year/month/day ap-
pears. Press REPEAT.
2. Setting the time format
Press UP or DOWN to select the desired time format --- 12h or 24h. Press REPEAT.
3. Setting the time
With the HOUR / MINUTE flashing in sequence, press UP or DOWN until the correct
hour/minute appears. Press REPEAT.
4. Setting the unit of measurement
Press UP or DOWN to switch between mg/dL and mmol/L. Press REPEAT.
5. Setting the buzzer
With the buzzer displays, press UP or DOWN to switch between "On" and "OFF". Press
REPEAT.
6. Deleting the memory
With a flashing "
and skip this step. To delete all the results, press UP and then a flashing "dEL" and "
will show on the display, press UP again to delete all the memory records.
7. Setting the reminder alarm
Your meter has four reminder alarms. The meter will display "OFF", "1st" and "
If you don't want to set an alarm, press REPEAT to select "OFF" and to skip this step.
If you want to set an alarm, press REPEAT to select "On".
With the hour/minute flashing in sequence, press UP or DOWN to select the desired
hour/minute. Press REPEAT and go to the next alarm setting.
NOTICE:
When the alarm is beeping: Press M to silence it; Or press and Hold M to switch it off; Or it
will beep for 2 minutes then switch itself off.
Congratulations! You have completed all the settings!
NOTE:
• These parameters can ONLY be changed in the settings mode.
• If the meter is idle for 3 minutes during the settings mode, it will switch off automatically.
" on the display, press REPEAT to keep the results in your memory
BewellConnect - BW-GL1 - User Manual - 022017v1
"
".
11