Installation Positions - Epson IM-800 Manual Del Usuario

English
Attaching the Rear Cover
The rear cover makes the back of the system look neat and protects
the cables.
1. When you want the cables to exit the top of the rear cover, use
pliers to break out the tabs.
CAUTION:
If burrs are left after the tabs are removed, they may cause cuts
or scratches. Remove the burrs with a cutter or file.
2. Remove the screw from the lower right corner of the back of the
unit.
3. Fit the tabs on the rear cover into the IM-800 as shown in
illustration E.
4. Attach with three screws including the one you removed. See
illustration F.
Dimensions
See illustration G. (Height is without rubber feet.)

Installation Positions

You can install the unit in either of the positions shown in
illustration H. The rubber feet are used only when the unit is
installed horizontally. Attach to the indentations on the bottom of
the unit.
WARNING:
If you set this product upright, be sure the ventilation opening is on the
top. Do not place any object on top of the ventilation opening. If the
ventilation opening is blocked, the product can be damaged by
overheating.
If you install this product horizontally, never place any object within
3 cm {1.2 inches} of the ventilation opening. If the ventilation opening is
blocked, the product can be damaged by overheating.
8 IM-800 User's Manual
All manuals and user guides at all-guides.com