Visel Italiana MP-VOICE Manual De Instalación página 6

MP-VOICE - User manual
(A) 12VCC: Connection to external power supply adap-
tor.
(B) COM: Connection to display (telephone socket -
standard);
(C) VOLUME: Keys + and – to regulate volume with
vocal level indication;
(D) OUT B.F.: Connection to an external amplifier;
(E) OUT: Connection to the loudspeaker;
NOTE: under the green carter there is a dip-switch
to set additional messages (scheme MESSAGES);
ATTENTION: Read this manual before using the product.
The MP-VOICE module is composed by a main unit and
a loudspeaker. An external power supply and cables are
provided for connection to the loudspeaker and the
display. Once these units have been correctly connec-
ted (scheme INSTALLATION), at each call, the MP-
VOICE announce the number shown on the display
(female mp-voice). The system is also able to link each
progressive number to a series of information available
by default. For further details see the scheme MESSA-
GES.
The product is also capable of memorising a message of
the customer's choice, which must be sent to the unit
using dedicated software (V-SOFTWARE). This message
may announce special offers, welcome, good wishes,
musical, etc., and must be made in MP3 digital format,
not exceeding the available memory fixed at approx.
400 Kbytes.
Scheme INSTALLATION - Plug the telephone socket of
the display to the COM (B) of the MP-VOICE by telepho-
ne cable in the kit. After, connect the loudspeaker to the
OUT socket (E) of the MP-VOICE. Finally plug display and
MP-VOICE (A) to power supply. If the connection was
made correctly you'll hear "TEST AUDIO OK". Now the
system is ready to use. Reading the scheme MESSAGES
it's possible to personalize the message with the following
indications:
Add "NOW SERVING NUMBER"
Add service letter "A" and "C"
Only progressive number
Counter
Teller
Room
e n g l i s h
Cod. 120
Cod. 121
Cod. 122
Cod. 123
Cod. 124
Cod. 125