Assembling The Left Refrigerator Door - LG LNXS30996 Serie El Manual Del Propietario

18 INSTALLATION
Assembling the Left Refrigerator
Door
Install the left refrigerator door after the right door is
installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator door
onto the middle hinge.
2
Fit the hinge (1) over the hinge lever latch and
slot it into place. Rotate the lever clockwise (2)
and fasten the hinge.
Hinge Lever Latch
3
Connect all the wire harnesses.
4
Push the water supply tube into the hole on the
top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet to connect the water supply line
as shown in (1). Insert the tube at least 5/8 inch
(15 mm) into the connector.
6
Make sure that the door-switch located inside the
cover is tightly connected. Place the cover (1) in
its position and tighten the cover screw (2).
NOTE
Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
• Gently press the collet and insert the tube until only
one line shows on the tube.
(Correct)
Collet
(Correct)
(Incorrect)