Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INFANT CAR SEAT
ATTATCHING SNAP TECH™ INFANT CAR SEAT
WARNING:
sliding out, always use the Infant Car Seat harness.
•
ONLY
approved Snap Tech™ products can be used on the frame.
7) • Attach the car seat by lining up the seat
anchors on the side of the car seat
with the anchors on the stroller frame
and push them together until they lock
securely (Fig. 7).
TO REMOVE INFANT CAR SEAT/ADAPTER
8) • To take off the infant car seat or adapter,
push both center buttons on each side of
the seat and lift the seat upwards (Fig.8).
DO NOT remove with child in the seat.
9
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Avoid serious injury from falling or
BRAKES
WARNING:
stroller is not being pushed so that the stroller will not
roll away. NEVER leave stroller unattended on a hill or
incline as the stroller may slide down the hill.
9) • To engage brakes, apply downward
pressure to the brake lever located on
the rear axle. The stroller might have to
be required to be rolled back and forth to
fully engage the brake (Fig. 9).
NOTE: Check that the stroller will not
move once the brakes are properly
applied.
• To release, gently lift up on the brake
lever.
Fig. 7
FRONT WHEEL LOCK
10) • The front wheels are equipped with a
swivel locking device. Push the button
on each wheel up to release the lock
and push downward to engage the lock
(Fig. 10).
Fig. 8
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
SAFETY
Always set brakes when the
Disengage Lock
Engage Lock
Fig. 9
Fig. 10
10
Tabla de contenido
