bloom fresco chrome Manual Del Usaurio página 23

eng
• Always secure child in the restraint.
• Never leave child unattended.
Section B: Cradle Mode
– suitable for 0 – 6 months (refer to
illustrations section b)
WARNINGS:
• Not recommended for children who can sit
up by themselves (6 months approximately).
• Never leave the child unattended when the
baby chair is in cradle mode.
• The child should be secured in the baby
chair at all times by the 5-point safety
harness in the reclining position.
• It is dangerous to put this cradle on an
elevated surface.
• Keep the product away from open fire,
heaters and other sources of strong heat.
• Do not use the product unless all
components are correctly fitted and
adjusted.
• Make sure harness is correctly fitted before
use.
• This reclined cradle is not intended for
prolonged periods of sleeping.
To install Seat Pad & Safety Harness Assembly
– (#07 seat pad, #09 safety harness) Put
shoulder straps through the seat pad slits at
the lower height setting.
– Put waist straps through the seat pad slits.
– Place seat pad onto the seat unit; secure onto
velcro. (refer to illustration b1)
4
– (#04 seat unit) Behind the seat pad, slide the
buckle on the end of the shoulder straps into
the buckle slots located on the inner face of
seat unit. Check the straps are secured by
pulling on the straps. (refer to illustration b2)
– (#12 storage compartment) Behind the seat
pad, pull open storage compartment door
located on the inner face of seat unit. Slide
the buckle on the end of the waist straps into
the buckle slots on either side of the storage
compartment. Check the straps are secured
by pulling on the straps.
– (#13 bar attachment caps, #14 crotch cover)
From storage compartment, take out the two
bar attachment caps and the crotch strap
cover. Close the compartment door.
– Insert the bar attachment caps on either side
of the seat unit; you will hear an audible click.
– Insert the loop on the end of the crotch strap
through the upper hole of the crotch strap
cover, and then put the loose end under the
crotch strap cover. Then slide the crotch strap
cover into the seat unit. The strap and buckle
must not be twisted or inverted. This will
ensure correct locking of the harness. (refer to
illustration b4)
– To remove the bar attachment caps, press
and hold the button under the two side
domes, and then press the side button on
dome cap to disengage the lock. And then
press the button on the crotch cover and
remove from the seat unit. (refer to illustration
b3)