Amann Girrbach ceramill argovent 2 Modo De Empleo página 26

I N S T A L L A T I O N
▷ Insert floor plate:
▪ For Argotherm: Reinsert previously removed
E N
floor plate again.
▪ For Argotherm 2: Insert (8 mm) floor plate
from Argovent 2 delivery scope.
Fig. 6
▷ Thread the hose piece of the Argovent sintering
base through the hole of the rear wall and slide
the sintering base to the stop into the furnace;
if required, apply a light jiggling motion.
The hose piece must completely project out of
the rear side of the furnace.
Fig. 7
26
▷ Insert the free end of the gas hose to the inter-
nal gas connection instead of the mounted hose.
Fig. 8
▷ Mount the push-in angle piece of the supplied
gas hose to the stop onto the hose piece of the
sintering base, until the resistance of the seal
has been overcome. When doing this, counter-
hold the sintering base in the furnace compart-
ment.
A click noise will indicate that the push-in con-
nection is properly engaged.
Fig. 9