Brudden MOVEMENT EXTENSORA IDEA Manual Del Usario página 80

MAINTENANCE
7
LOCKING STEEL CABLE
Always check that the screws are securely fastened to the plates. If the locks are damaged, do
not allow the equipment to be used. Contact Technical Assistance to make the change.
SNAP LINK
Some models use snap link , so it is extremely important to check the condition of the carabiner.
At the slightest sign of wear, deformation, difficulty to close and anything that could be
detrimental to its resistance, replace the snap link immediately
REPLACEMENT CARABINER
For the replacement, always use a snap link supplied directly by MOVEMENT. If it is not possible
to obtain a snap link supplied by MOVEMENT, use a snap link that strictly meets the following
requirements.
-Material composition: Stainless steel AISI 316;
- Maximum closed capacity: 1600kg;
- Maximum open capacity: 350kg
-Monthly, verify with attention the conditions
of the snap link ;
- Do not modify the snap link in any way;
- The opening of the snap link must be
ATTENTION!
turned to the weights column.
STEEL CABLE
During the equipment use the cable may be damaged for misuse or lack of maintenance.
Sometimes the steel cable can be damaged even if it is not shown if it is damaged. Stay alert and
always observe any kind of problem as a cable. Do not use and do not allow the equipment to be
used if the steel cable is damaged. Below are some examples of damaged steel cable.
TWISTED STEEL CABLE
Always check the steel cable if you find twists immediately replace the cable.
BULGES ON THE STEEL CABLE
If the cable ruptures internally, a bulge may emerge on the exterior part of the cable, replace the
cable immediately.
36