Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. FAULT FINDING GUIDE
Repaining a sound mixing console requires spe-
cialist, but basic fault finding is whitin the scope of
any user if a few badic rules followed.
•
Get to know the block Diagram of your con-
sole.
•
Get to know what each component in the sys-
tem is supposed to do.
•
Learn where to look for common trouble
spots.
The Block diagram is a representative sketch o
fall the components of the console; showing how
they connect together and how the signal flows
through the system. Once you have become fa-
miliar with the various component have gained a
7. CAUNTIONS ON INSTALLATION
Please take care of the following points for instal-
lations.
1. Install this product at place of good ventilation
and keep a interval over 30cm from the other
objects.
2. Install this product at rear side for non-touch-
ing of somebody, if possible and avoid an
installation of a aisle & the front side of the
stage.
3. Cause an obstacle and an drop of product
from the vibration of speaker, if you put this
product one speaker for a long time.
4. Avoid strong or using product in condition of
P. 10
AUDIOLAB LIVE AN16 -
English version
valuable understand of the internal structure of
the console and tracking down the problem by
elimination.
•
Swap input connections to check that the
source is really present. Check both Mic and
Line inputs.
•
Eliminate sections of the channel by using
the insert point to re-route the signal to oth-
er inputs that are konbs to be working.
•
Route channels to different outputs or to aux
sends to identify problems on the master
section.
•
Compare a suspect channel with an adjacent
channel which had been set up identically.
Use PFL to monitor the signal in each section.
excessive heat or cold, or in position where
it is likely to be subject to vibration, dust or
moisture.
5. Connect the plug into an outlet by the check
of power source "AC 220V" of the installa-
tionplace.
6. Install the speaker more front side than the
used mic and for away from mic, if possible.
7. Insert a plug of cord closely into the speaker
jack at the speaker connection.
8. Clean this product by using soft dry cloth &
poly-wax.
Tabla de contenido
