Preparing The Siren; Tooling Required; Opening The Siren And Connecting The Power Supply - DAITEM SH402AX Manual De Instalación

GB
Example: The system is in Armed Partial 2 mode but the siren has a battery fault. When the
"system status query" order is sent from the keypad or remote control, the control panel and
siren issue the following vocal messages:
Bip, system_status, armed Partial 2,
bip, 12/03 at 12:00, Fault, Voltage,

2. Preparing the siren

2.1 Tooling required

2.2 Opening the siren and connecting the power supply

1. Insert a screwdriver into the
bottom right-hand corner
between the base and the
siren and apply pressure to
open the siren.
Remote_control_unit 1"
6 mm
2. Place the siren on a flat surface, remove the base
PZ 2
iMPoRtAnt: the fixing screws
and wall plugs are not supplied.
by inclining it at a 45° angle (A) and pull it
downwards (B).
A
45°
94
"Bip, armed Partial 2,
bip, Fault, system"
B