Dremel 760 Golf Club Manual Del Propietário página 14

Set the speed indicator to fit the job to achieve the
best job results when working with different
materials.
To select the right speed for each job, use a prac-
tice piece of material. Vary speed to find the best
speed for the accessory you are using and the job
to be done.
On the Model 760, there is a LO and HI switch.
When the switch indicator is in position 1 or LO, the
tool runs at about 7,000 RPM. When the switch
indicator is in position 2 or HI, the tool runs at about
14,000 RPM.
NOTE: Speed is affected by voltage changes.
Weaker batteries with reduced voltage will slow the
RPM of the tool, especially at the lowest setting. If
your tool appears to be running more slowly than
normal, replace the batteries with fresh ones to
increase tool speed.
Most applications using the 760 Golf Club Cleaning
Tool can be accomplished using the HI speed set-
ting (position 2). The HI speed setting (position 2)
Service
!
NO USER SERVICEABLE PARTS
WARNING
INSIDE. Preventive mainte-
nance performed by unauthorized personnel may
result in misplacing of internal wires and compo-
nents which could cause serious hazard. We
recommend that all tool service be performed by a
Dremel Service Facility.
D.C. motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain peak
efficiency of the motor, we recommend it be exam-
ined every six months. Only a genuine Dremel
replacement motor specially designed for your tool
should be used.
Operating Speeds For Accessories
Maintenance
is recommended when using the 403 bristle and
535 wire brush accessories included with the tool.
LO speed is needed only for certain tasks when
more control in needed.
The speed of Model 760 is controlled by
setting this indicator on the housing.
Cleaning
!
WARNING
cleaning. The tool may be cleaned most effectively
with compressed dry air. Always wear safety gog-
gles when cleaning tools with compressed air.
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not attempt to
clean by inserting pointed objects through opening.
!
CAUTION
Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and house-
hold detergents that contain ammonia.
Page 14
To avoid accidents, always dis-
connect battery pack before
Certain cleaning agents and sol-
vents damage plastic parts.