Maintenance - Snap-On 870968 Manual De Instrucciones Para La Instalación, Uso Y Mantenimiento

detergent and reduces its cleaning ability.
7. Allow detergent to "soak in" for 3-5 minutes before washing and rinsing. Reapply as
needed to prevent surface from drying. Do Not allow detergent to dry on surface (prevents
streaking).
TO RINSE:
1. Reset the Pressure Adjust Collar to high pressure, press the trigger and wait for the deter-
gent to clear.
2. Keep the spray gun a safe distance from the area you plan to spray.
3. Apply a high pressure spray to a small area, and then check the surface for damage. If no
damage is found, it is okay to continue cleaning.
4. Start at the top of the area to be rinsed, working down with same overlapping strokes as
you used for washing and applying detergent.
When you have completed use of the detergent injection system, continue to run in low pres-
sure position and flush clean water through the detergent tank until it is thoroughly cleaned.
clogged and inoperable.
Stop the unit by pressing the ON/OFF button.
Disconnect electrical plug.
Turn off water and depressurize unit by squeezing trigger.
CLEANING TIPS:
• Never leave the Pressure Washer unattended while it is plugged into an electrical outlet
and while water is supplied to the equipment.
• Never use the Pressure Washer water inlet to siphon detergent or wax.
• If you have the nozzle too far away from the surface being washed, the cleaning will not be
as effective.
IMPORTANT: DO NOT get closer than 6 inches when cleaning.
Regular maintenance will improve performance and extend life of Pressure Washer.
Pressure Washer's warranty does not cover items that have been subjected to operator abuse or
negligence. Only by maintaining Pressure Washer in accordance with instructions in this manual
will the full value of the warranty be honored.
Wetting the surface first is not recommended, as it dilutes the
Failure to clean properly will cause the injection system to become

MAINTENANCE

15