Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SYMBOLS
Read the operator's manual.
Warning
Double insulation
Fuse
Positive terminal
Negative terminal
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
CHARGING PROCEDURE
NOTE: Before using the charger, read the
instruction book carefully.
HOW TO USE YOUR CHARGER
Plug charger directly into an electrical outlet. DO
1.
NOT ABUSE THE CORD. Never carry charger
by cord. Do not disconnect the charger from the
outlet by pulling it by the cord.
CAUTION: To reduce the risk of fire,
2.
electrical shock, or personal injury do
not attempt to use this charger with any other
product.
Likewise, do not attempt to charge the mower
with any other charger.
3.
Do not operate a damaged charger. Replace
damaged cords or charger immediately at an
authorized WORX service depot.
4.
Do not charge in wet locations. Do not charge
mower when temperature is above 104°F (40°C)
or below 41°F (5°C).
5.
Keep the mower and charger away from water,
heat sources, (such as radiators, heaters,
stoves...etc.) flames, or chemicals. Be careful not
to damage the charger cord, by keeping cord
away from sharp edges.
28V Robot lawn mower charger
CONNECTING THE CHARGING STATION
(See Fig. A, B)
1.
Connect the low voltage cable of the charging
station to the charger. When connecting, align
the notch on the power cord connector (a)
with the groove on the adaptor connector (b).
The connectors may be slightly difficult to
connect, as they are moisture-proof, tighten the
connectors firmly.
2.
Connect the charger's power cord to a wall
socket. It is preferable to use an earth-fault
breaker as recommended.
CHARGING A DISCHARGED BATTERY (See Fig. C)
When WORX Landroid
®
for a long period, the battery will not be charged and
needs to be charged before starting. Charging takes
between 1 and 2 hours.
1)
Place Landroid
in the charging station. Insert the
®
mower as far as possible. (See C)
Good contact is made when both the charging
strips on the mower touch the centre of the
contact strips on the charging station.
2)
Open the control panel cover. Press on/off button
to start, and press Home button.
3)
Close the control panel cover. The charging base
red light will turn on, while "charging" is shown
on the screen.
MAINTENANCE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Your charger requires no additional lubrication or
maintenance. Never use water or chemical cleaners
to clean your charger. Wipe clean with a dry cloth.
Always store your charger in a dry place.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
is new or has been stored
EN
5
Tabla de contenido
