Locating Your Built-In Hob - SUNFEEL PLV4FBT Instrucciones De Instalación Y Funcionamiento

INSTALLATION
The electrical connection of this hob
should be carried out by an authorised
service personal or a qualified electri-
cian according to the instructions in this
guide and in compliance with the cur-
rent regulations.
• Before connecting your appliance
to the mains at home, make sure to
check the conformity of voltage set-
tings, which are specified on the infor-
mation check the conformity of volt-
age settings, which are specified on
the information available.
• The laws, ordinances, directives and
standards in force in the country of
use are to be followed (safety regula-
tions, proper recycling in accordance
with the regulations, etc.)

Locating your built-in hob

After removing the packaging material
from the appliance and its accessories,
ensure that the hob is not damaged. If
you suspect any damage, do not use
the appliance and contact authorised
service personnel or a qualified electri-
cian immediately.
This built-in hob is to be inserted into a
cut-out in a worktop.
Create an opening with the dimensions
shown in the next illustration. The dis-
tance between the rear edge of the hob
and any adjacent wall is depend on
wall surface. Please don't use easily
combustible material like curtain, paper
near the hob.
Neighbour-
hood walls
Combustible/
Non-com-
bustible
• Apply the one-sided self-adhesive
sealing tape supplied all the way
round the lower edge of the cooking
surface along the outer edge of the
glass ceramic panel. Do not stretch it.
• Screw the four worktop mounting
brackets on the side walls of product
Worktop mounting bracket
worktop mounting bracket
EN -7-
A (mm) B (mm)
50
50
Neighboorhood w
Combustible
Non-combustibl