Sanus ML11 Manual De Instrucciones página 8

3 Mount the Wall Plate
Solid Concrete or Concrete Block
3-1
Mark the wall
[01]
3-2
Drill pilot holes
3-3
Insert anchors and lag bolts
[04]
[04]
8
75 mm
(3 in.)
[01]
[05]
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!

Mount the wall plate [01] directly onto the concrete surface.

Minimum solid concrete thickness: 203mm (8 in.).

Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.).

Minimum space between fasteners: 406 mm (16 in.).
CAUTION:
Avoid potential injuries or property damage!

Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10
mm (3/8 in.) diameter drill bit.

Never drill into the mortar between blocks.
Insert lag bolt anchors [04]. Then insert lag bolts [03] using a drill and
the allen driver bit [05].
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:

Be sure the anchors [04] seat fl ush with the concrete surface.

Tighten the lag bolts [03] only until the they are pulled fi rmly
against the wall plate [01].

DO NOT over-tighten the lag bolts [03].
[04]
[03]
10 mm (3/8 in.)
6901-172002 02