Installation; Sediment Filter Assembly; Sediment Filter Installation - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

Installation

Sediment Filter Assembly

Sediment Filter Cover
Blue Sediment Filter Housing
Figure 5
1. Unscrew the cover from the Blue Sediment Filter Housing.
2. Remove the plastic covering from the Sediment Filter.
3. Place the Sediment Filter onto the Stand Pipe in the Blue Filter Housing.
4. Screw the cover onto the Blue Filter Housing until hand-tight.

Sediment Filter Installation

Inlet Water
Supply
Figure 6
Notice:
The Sediment Filter can be installed in either a pre or post position.
1. Shut off the water.
2. Attach the Mounting Bracket to the wall using the supplied Phillips Head Screws .
3. Attach the Sediment Filter System to the Mounting Bracket using the supplied Bolt Head Screws
and washers.
4. Tighten the Blue Filter Housing using the supplied Filter Wrench (counter clockwise) Do Not
Over Tighten.
Notice:
The Sediment Filter Housing comes with a 1" threaded female inlet/outlet and will require additional
fittings to adapt to your plumbing. A shut-off valve is recommended prior to the System.
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Sediment Filter
O-Ring
Stand Pipe
Mounting
Top View
Bracket
Blue Sediment Filter Housing
www.envirowaterproducts.com
Rev C
Page 9