Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Installation work and electrical wiring must be done
by qualified person(s) in accordance with all appli-
cable codes and standards, including fire-related
construction.
B. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection Associa-
tion (NFPA), and the American Society for Heating,
Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
C
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
E. Always unplug or disconnect the downdraft from the
power supply before servicing.
F. This unit is designed for indoor use only. Use this
unit only in the manner intended by the manufac-
turer.
This unit is manufactured for indoor use only. Do not use
this unit outdoors.
Parts Needed
•
Blower (Remote or Integral)
•
Tape Measure
•
Phillips Head Screwdriver
•
Duct Tape
•
Ductwork (configuration varies depending on location;
See pages 4-7 for further information)
•
Additional Sheetmetal screws (as necessary for
ductwork installation)
•
Transition(s) (style varies depending on ductwork)
Transition box for remote blower installations is available
as an accessory.
•
Saw (or equivalent for cutting countertop)
•
#8 x 1 1/4" Wood Screws (4)
SAFETY INSTRUCTIONS
Read All Instructions Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS
WARNING
CAUTION: For general ventilating use only. Do
not use to exhaust hazardous or explosive materi-
als and vapors.
To reduce risk of fire and to properly exhaust air,
be sure to duct air outside. Do not vent exhaust
air into spaces within walls, ceilings, attics, crawl
spaces or garages.
TO REDUCE THE RISK OF FIRE, USE ONLY
METAL DUCT WORK.
To reduce the risk of fire, electric shock and injury
to persons, ventilator assemblies, All DHD models
must be installed with integral blower, model
DHG601DUC or remote blower models
DHG6003UC or DHG1003UC. Other ventilator
blowers cannot be substituted.
To reduce the risk of fire or electric shock, do not
use the fan with any solid-state speed control
device.
This appliance has been found to be in compli-
ance with UL507 Standard for Electric Fans and
CAN/CSA-22.2 No. 113 Canadian Standard doe
Fans and Ventilators. It is the responsibility of the
owner and the installer to determine if additional
requirement or standards apply in specific installa-
tions.
Parts Supplied
•
Downdraft assembly (1)
•
#8 Sheetmetal Screws (8)
•
Blower Cord Traction Relief (1)
•
Hardware for brackets on vent (2)
•
Remote Blower Pigtail
Page 1
Tabla de contenido
