Kalorik SIS 40516 Manual De Instrucciones página 5

Fax +1 305 430 9692
CAUTION BEFORE FIRST USE
•
Please read all of the instructions for use and the "Important
Safeguards" carefully.
•
The iron has been greased, and as a result, the iron may slightly
smoke when switched on for the first time. After a short while, this
will cease.
•
Before using for the first time, remove all packaging from the
appliance.
•
Before the first use, we recommend cleaning the iron as follows: fill
the water tank and plug the appliance into an outlet. Press the
boiler power switch and the iron power switch. Put the
temperature dial on the "LINEN" position and the steam regulator
on MAX. Let the iron heat for 10 minutes. When the iron is hot, lift it
from its base, hold it vertically, and keep the steam button pressed
for 30 seconds, then wait 30 seconds and repeat this cycle twice.
Switch the appliance OFF (set the boiler power switch and the iron
power switch in the off-position), unplug it, and let it cool. You can
then clean the soleplate with a damp cloth.
HINTS
•
Before using the appliance for the first time, hold the iron away
from your clothes and press the steam control trigger several times
consecutively. This will remove any cold water from the steam
connection cord. This should also be done if you have not used
the steam function for a few minutes while the appliance is in use.
•
For best results, use a mesh-type ironing board to allow excess
steam to escape.
IRONING: PRECAUTION FOR USE AND
TEMPERATURES
•
Before ironing, always be sure to check the ironing instructions on
all fabric labels. Follow these ironing instructions.
•
If ironing instructions are missing, you may reference the following
table for recommended ironing temperatures by fabric type:
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
5
Assembly page 5/40
SIS 40716 - 120501