VCC – VIDEO CAPTURE CARD FOR 4 CAMERAS
1. Introduction
Thank you for buying the VCC PCI 4 port video capture card! Please read the manual thoroughly before bringing this device
into service. Make sure that the device was not damaged in transit. If the device is damaged, you should contact your dealer.
Verify if all parts are included: a VCC video capture card, a driver CD and this user manual.
2. Specifications
Chipset
Bus interface
Video inputs
Video format
Software required
System requirement
3. Installation
a. Before Installation
Hardware: as the VCC is a PCI video capture card, make sure there is a PCI slot available in your PC.
Software: make sure Microsoft™ DirectX8.0 or higher is installed in Win98/ME/2K/XP.
On the component side of the card, the jumper
on connector J3 determines what input channel
is sent out through the output connector:
b. Installing the video capture card
1. Power off your PC, disconnect the power cord and open the housing.
2. Insert the video card into the available PCI slot and fasten the attachment screws.
3. Close the housing, reconnect the power cord and power on your PC.
c. Installing the PV143 driver under Win98/ME/2K/XP
NOTE: before installing the PV143 driver, check if you have the BT878 driver installed. If so, please uninstall the
BT878 driver completely to avoid compatibility problems with the PV143 driver.
1. Insert the CD into the CDROM drive (here we assume this is the E drive)
2. New hardware (the video card) will be detected and an "add new hardware wizard" dialogue box will appear.
3. Click next and select the driver source as E:\PV143\XXX\Driver\Win98/ME/2K/XP (XXX refers to the subfolder -
which one depends on the resolution you want: folder "320" for 320x240 or "640" for 640x480).
4. The BT878 video/audio drivers will automatically be installed in your system
5. After successfully installing the drivers, you can find them in your system properties, on the 'Device Manager' tab,
under "Sound, video and game controllers".
VCC
Conexant (BrookTree) Bt878/878A
PCI v2.1 compliant
4 RCA jacks
NTSC/PAL/SECAM
Win 98/ME/2K/XP OS, Microsoft™ DirectX8.0
IBM 32bit compatible PC
128MB RAM
2x CDROM drive
PCI/AGP card and monitor
TO TV SET
SOURCE_1
SOURCE_2
SOURCE_3
SOURCE_4
1
J3
1-2 (DEFAULT)
3-4
5-6
7-8
VELLEMAN