Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Default settings
•
Flash detection mode: type approved.
•
Programmed code for connection in
systems 300: 65535.
•
Flash interception: disabled.
Entering and exiting the
programming functions
In order to enter programming mode via
the telephone connected to the telephone
interface:
Lift the receiver
or
press the hands-free key.
Press
set/telephone transfer key.
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
Key in 9999.
PQRS
TUV
WXYZ
7
8
9
0
During this phase, one or more programming
procedures can be carried out in a row.
The programming codes must be entered
during the pause in the programming tone.
In order to exit programming mode:
Lift the receiver
or
press the hands-free key.
Following this operation, a double tone
should sound, prompting you to commence
programming.
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
Key in 9999.
PQRS
TUV
WXYZ
7
8
9
0
Once finished, you should hear the local
line dial tone.
PROGRAMMING
the
entry
hand-
Programming the power supplier
or X1/X2 systems identification
code with non-BPT telephones
Set the XA/300LR power supplier to exten-
sion programming mode by pressing the
SERVICE key for at least 3 seconds.
Set the X1/X2 system for internal receiver
programming, removing jumper SW2 from
the entry panel (AZV/304, AZ/304, HET/301,
HEC/301 and HEV/301).
To enter programming of the IT/300, close
the jumper SW1 for 3÷4 seconds and re-
open it.
Lift the receiver
or
press the hands-free key
(if present).
Following this operation, a double tone
should sound, prompting you to commence
programming.
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
Enter R86 or 86 (for telepho-
PQRS
TUV
WXYZ
7
8
9
nes without the R key).
0
There should be an audio link between the
entry panel and the telephone.
Enter the identification code by pressing the
call button on the entry panel.
Lift the receiver
or
press the hands-free key.
24
Capítulos
Tabla de contenido
