Electrical Connection; Complete The Installation; Description Of The Hood; Control - ELICA EAL330S1 Guía De Instalación, Uso Y Mantenimiento

Electrical Connection

I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
TURN OFF POWER CIRCUIT AT THE SERVICE PANEL
BEFORE WIRING THIS UNIT.
120 VAC, 15 OR 20 AMP CIRCUIT REQUIRED.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNC-
TION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW)
SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU
AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE
MUST BE CONNECTED TO THE GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO
CIRCUMSTANCES BE CUT OR REMOVED.
Failure to do so can result in death or electrical shock.
• Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A. Knockout
B. Junction box cover
• Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordinances,
in ⁄ " conduit from service panel to junction box.
1
2
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.
A
B
Complete Installation
Replace filters.
Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house
fuse blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood,
read the "Mainteinance" section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.

Description of the Hood

1
2
3
1.
Blower and light controls
2.
LED lamps
3. Grease filter handle
4.
Grease filter
Controls
1.
Light On/Off button
2.
Blower On/Off button
3. Blower speed minimum button
4.
Blower speed medium button
5.
Blower speed maximum button
NOTE: Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (1) controls both lights. Press once
for On and again for Off.
Operating the blower
The Blower On/Off button (2) turns the blower On or Off.
The Blower Speed buttons (3, 4 and 5) set the desired speed
and control the sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired blower speed button.
1 To turn the blower On, press the Blower On/Off button (2)
and the desired speed button (3, 4 or 5).
2 To turn the blower Off, press the Blower On/Off button (2).
Any of the 3 blower speed buttons can be in the On position
at the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.
3
4
9