Tabla de contenido
2
Carefully lift tunnel
assembly and position it
at the desired location
making sure it is level.
Press firmly for 10
seconds at each clip
location along the
length of the assembly
to secure the clips
and clip
24
wall.
3
23
23
24
to the
23
Peel the tunnels
away from
25
25
the clips
23
and
.
24
25
4
23
Arrange your wires on either
side of the clips.Reattach
the tunnels
25
and clip
23
sure to capture the wires
behind them. Press firmly
24
along the length of the
tunnels where the clips are
located until clips snap in
place.
NOTE: Leave enough slack in the
cables/wires above the tunnel to
prevent them from interfering with
25
or rubbing against the tunnel when
moving the TV. This could cause the
tunnel to separate from the clips.
TIP: Taping the cables/wires in
place above and below the tunnels
to hold them will make reattaching
the tunnels easier.
to the clips
25
making
24
19
Tabla de contenido
