Saivod CP-215M Manual De Instrucciones página 15

 Remote control.
 Overheat protection.
 Water protection : IPX2.
INSTALLATION:
Drill two holes in wall and have a distance of 2,05m from the ground. The diameter of the hole just
contained the inflated plastic pipe. After tucked the inflated plastic pipe, fixed pothook on the pipe with
screw. Make sure pothook fastness and hang the heater. The clip under the pothook should be inserted
rabbet of the heater bottom.
FUNCTION INSTRUCTION
MACHINE PANEL
Plug the cord into the electrical socket (220-240V~AC) and the power indicator light will be on.
Turn the heater on by pressing the " " button and the product will blow natural wind (fan mode). To
turn off the heater, press the " " button and 30 seconds later the product will stop working.
MODE
GB
Pressing the "MODE" button the heater will work at low heat mode (1000W)
Pressing the "MODE" button for second time, the heater will work at high mode (2000W).
TIMER
The timer function allows you to set the length of operation from 0.5 hour to 7.5 hours
Remark: All light on panel will be shown on the working state.
15
CP-215.indd 15 6/1/2016 11:27:49 AM