Installation / Connecting Power; Getting Ready For Operation; Working With The Access B400 - Frama ACCESS B400 Manual De Operación

Frama Access B400
2.2 Note about possible damage to machine support surface
Please bear in mind that present-day furniture is coated with many different paints and plastics. It is
thus quite possible that one or the other of these materials contains constituents that attack or soften
the plastic feet of the machine. If changed in this way by foreign substances, the feet of our equipment
can leave marks on surfaces of your furniture. Frama is unable to accept any liability for damage of this
kind for obvious reasons. With this in mind, use a non-slip underlay.

3. Installation / connecting power

3.1 Positioning the Access B400
Place the letter opener on a horizontal surface, observing the instructions under 2.2. Position the letter
collecting tray (12) to the right of the machine.
3.2 Connecting to mains electricity supply
Without presetting, the letter opener is ready for service
with a mains electricity supply between 100 and 240V and
a frequency of 50 or 60 Hz.
Connect the power supply unit (1) to the power connector
(2). Connect the mains cable suitable for your country to
the power supply unit (1) and the socket.
Attention! The socket must be close to the letter opener
and easily accessible.

4. Getting ready for operation

Place the mains switch (3) at the back of the appliance to po-
sition "1". The diode (4) at the front side glows steadily red to
indicate that the letter opener is ready for operation.
On ecological grounds, please switch off the letter opener
after use via the mains switch (3) (diode (4) goes dark).

5. Working with the Access B400

5.1 Pre-sorting / readying letters for opening
Following the preparatory steps below will greatly aid problem-free letter opening thereafter. Please
observe these instructions:
Separate out letters that are thicker than 10 mm and open them by hand. The Access B400

adapts automatically to letter thicknesses up to 10 mm.
Separate out large-sized letters (e.g. C4 / B4 formats) and short letters (e.g. C6), and open them

separately using the Access B400.
Other letter formats with the same or closely similar length (e.g. C6/5, C5, B5 etc.) may be mixed

together for opening.
8
1
2
4
3