Marmitek GIGAVIDEO800 HDMI Modo De Empleo página 4

GIGAVIDEO 800 RECEIVER CONNECTIONS
1. Connect your HDTV or HD Projector (HDMI IN) to the GV800 Receiver (HDMI OUT) by the supplied HDMI cable.
2. Connect the supplied power adapter between the DC IN of the GV800 Receiver and a power outlet.
Note:
Use the supplied drill hole drawing, 2 anchors and 2 screws if you want to mount the GV800 Receiver to the wall (e.g.
behind your HDTV).
CONNECT THE INFRARED BLASTER & SENSOR (if necessary)
1. Plug the IR sensor extender cable into the IR IN jack of the GV800 Receiver and place in the line of sight of the
remote control.
2. Plug the IR blaster extender cable into the IR OUT jack of the GV800 Transmitter. Place the IR blaster LED in
front of your HD devices and it will transmit all infrared commands received by the IR sensor extender cable.
Note:
x
IR blaster only supports 38kHz (NEC) and 36kHz (RC5 & RC6) infrared remote protocols. Some devices may not
be supported.
4 GIGAVIDEO800 HDMI™