Tabla de contenido
Nota Importante
TROUBLE SHOOTINGS
CAUTION: Disconnect the power supply before servicing.
1
STATUS
The power
1 - 2
supply is
damaged
2
3
The motor does
4 - 5- 6 -7 - 8
not run
9 - 10 - 11
1 2
1 2
The unit body
shake
13
14 - 15
1 6
Big noise
Suction not so
powerful
Bulb does not
work
CAUSE AND METHOD OF REPAIRING
If the power supply is damaged,please call
technicians to repair.
a) The motor was broken, replace a new motor
assembly.
b) The switch control was broken, replace a new
switch control.
c) The capacitance was broken, replace a new
capacitance.
a) The installation is not firm enough. Check it and
make sure the hood is firm enough.
b)The fan is broken, so it is not balance. Replace a
new motor assembly.
c) The motor does not firm enough. Check it and
install it firmly enough.
a) Some other things drop to the blower. Check and
clean it.
a) The distance from the cooker hood to the gas
cooker is too big. Make sure the distance is about
650-700mm.
b) There are many windows or doors in the kitchen,
the air convection is too big. Close some doors or
windows, smaller the air convection.
c) There have some other pour wind to the exhaust
pipe. Make the exhaust pipe's exit to downwards.
d) The run rate of motor decrease obviously. Replace
a new motor or capacitance. Because of the cooker
hood is set upon the window, the best solution is
that put one threeply board on the back of the
cooker hood for covering the hollow of window.
Replace with a new LED lamp assembly.
16
TOOL
"+" type
the
Screwdriver
Sharp Pincers
"+" type
Screwdriver
"+" type
Screwdriver
"+" type
Screwdriver
"+" type
Screwdriver
"+" type
Screwdriver
Tabla de contenido
