KREA Swiss hotCHOC Manual De Instrucciones página 7

through the nozzle and suction tube can ease the cleaning process. Rinse thoroughly
thereafter with hot clean water.
The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and film available on our
website: www.kreaswiss.com. In most cases a part has been forgotten or the product
needs a thorough cleaning. If your issue persists, please contact your reseller for
additional support. Please always include the article number (page 15) in any
correspondence.
DISMANTLING AND ASSEMBLING (see page 15)
 Unscrew the round jet nozzle (9) and slide off the nozzle heating unit (14).
 Then unscrew the bent nozzle extension (8) from the pump housing (5).
 Remove the 3 piece "atomiser unit" (7) from inside the chamber. The metal adapter
(6) should never be removed. Place all parts in a small dish and clean them
following the cleaning steps outlined earlier. The suction tube (10), container (11),
container insulation sleeve (12) and nozzle insulation sleeve (13) can be washed
in the sink.
 Remove the service screw (2) and take off the pump housing (5). Put the piston
(3), piston spring (4) and hood (1) to one side and wipe them down as outlined
above.
 To assemble the gun, do so in reverse order.
 The piston should move freely in the pump housing.
 Ensure the service screw, bent nozzle extension and round jet nozzle pieces are all
screwed on tightly.
7