kayami S-10/20-M Manual Del Usuario página 20

Calor instantaneo
AND MAINTENANCE
INSTALATION
4
DESCRIPTION
OF THE PARTS
- If the heater is not going to be used in a big period of time, clean it
CLEANING
periodically to avoid that the dust gets inside the device or save inside
its box in a dry place.
- Before cleaning the device switch it off. Wait until it gets cold and
the ventilator stops. When the heater stops we could unplug the wire
and start cleaning the device. Clean the superficies of the heater with
a smooth and clean cloth. Do not clean the device directly with water,
dissolvent, alcohol, gasoline or similar.
Observe the heater in the backside. See that in the superior side
of the device there is a hole prepared to introduce a screw. To install
correctly the device you should make two holes in the wall 1,8 meters
from the floor. The hole's diameter will depend on the screw we are
going to use. Let the screws 10 mm out of the wall and when they are
well fixed put the device on.
Central body of the heater Air inlet
Air outlet
Frontside panel
Control panel