Tabla de contenido
As s e m b l y / M o u n t i n g
1. Break in the new Air Compressor as follows:
a. Turn the Power Switch off and unplug the unit.
Insert a male coupler (sold separately)
into the female Quick Coupler and fully
open all regulators and valves.
b. Plug in the Power Cord.
c. Turn the Power Switch ON.
d. Let the unit run for 30 minutes.
Air will expel freely through the Coupler.
e. Turn the Power Switch OFF.
f. Unplug the Power Cord and
remove the male coupler.
Item 60637
F o r t e c h n i c a l q u e s t i o n s , p l e a s e c a l l 1 - 8 8 8 - 8 6 6 - 5 7 9 7 .
2. Connect a regulator valve, an inline shut off valve
and a 1/4" NPT air hose to the Quick Coupler
(all sold separately). The air hose must be long
enough to reach the work area with enough extra
length to allow free movement while working.
No t e : An i n - l i n e s h u t o f f b a l l v a l v e i s a n i m p o r t a n t
s a f e t y d e v i c e b e c a u s e i t c o n t r o l s t h e a i r s u p p l y e v e n
i f t h e a i r h o s e i s r u p t u r e d . T h e s h u t o f f v a l v e s h o u l d
b e a b a l l v a l v e b e c a u s e i t c a n b e c l o s e d q u i c k l y .
3. Depending on the tool which you will be
using with this compressor, you may need to
incorporate additional components, such as an
in-line oiler, a filter, or a dryer (all sold separately),
as shown on Figure A on page 8 and
Figure B on page 9. Consult your air
tool's manual for needed accessories.
Page 7
Tabla de contenido
