Kuppersbusch KD 674.1GE Instrucciones De Uso Y De Montaje página 21

- Remove the plug from the upper part of
the ducting fan unit (fig. 17), as it is not
possible to insert the flange F with the
plug in place.
- Fit the flange F Ø120 or 150 mm (fig.
18), replace the plug.
· Air outlet directed to the right or left
hand side (fig. 4a-b).
- Remove the four screws fastening the
plastic frame, as shown in fig. 16.
- Fit the ducting spigot R (fig. 19) and replace
the four screws removed as above.
3 - Fixing the chimney
a) Loosen the screws M fixing the two parts
of the chimney and pull the inner section I (fig. 20)
almost all the way out. Remove the protective film P.
b) Rest the lower section of the chimney in its housing on
the top of the hood canopy. Lower the ducting fan unit
until it reaches the wall bracket S and fix it using the
screw H provided (fig. 21). Fit the cover D (provided)
on the wall bracket S (fig. 22).
c) Insert gasket G1 (found in the accessory bag) on the
base of chimney stack A, so
that it adheres perfectly to the
shape of chimney stack A. Then
fix chimney stack A to the hood
unit C using four of the screws
provided E (fig. 23).
d) Insert the transparent seal Q
(provided), so as to eliminate
any play between the two parts
of the chimney (fig. 24). Lock
the screws M.
e) Remove the support rod B.
2 2
2 2
Part 1 - INSTALLATION INSTRUCTIONS
2 4
2 4
1 7
1 7
1 8
1 8
1 9
1 9
2 1
2 1
A
E
E
A08_TL
2 0
2 0
2 3
2 3
G1
C
E
E
21