Max 46002 Manual De Instrucciones página 30

Preparation and adjustment
Adjusting the parallel guide
Adjust the parallel guide (16) to the desired
distance from the blade (9) and tighten the
wing screw (7).
br br
7
Setting the bevel angle
Release the baseplate angle adjustment
knob (6) on the front of the saw, and rotate
the upper part of the saw to the desired
angle (0-45° from vertical). The angle can be
read off the angle gauge (5). Retighten the
bevel adjustment knob.
The two markings (8) of the saw line can be
used when the saw blade is set to 0 and 45
degrees respectively.
7
br
8
0° 45°
5
6
Adjusting the cutting depth
The cutting depth can be adjusted by
loosening the depth adjustment screw (15)
and angling the upper part of the circular
saw until the blade is at the desired cutting
depth relative to the baseplate.
Re-tighten the depth adjustment knob. The
cutting depth can be read off from the depth
gauge (14) and this must be at least 3 mm
more than the thickness of the workpiece.
Note: The cutting depth cannot be reduced if
the saw is set up for bevelling!
bq bq
Connecting dust extractor
If necessary, attach a vacuum hose or a dust
collector hose to the nozzle outlet (1).
GB
bp bp
30