Custom Panels - Sub-Zero IC-18FI Guia De Instalacion

PANEL INSTALLATION

Custom Panels

For integrated models, custom door panels and handle
hardware must be installed. Stainless steel panels are
available through an authorized Sub-Zero dealer. For local
dealer information, visit the find a showroom section of our
website, subzero.com.
The thickness of the custom panel can vary. A minimum
5 / " thick panel is required, but the thickness can be
(16)
8
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
integrated model is 24"
(610)
planning the finished opening depth.
PANEL REQUIREMENTS
PANEL WEIGHT
18" Column
24" Column
30" Column
36" Column
PANEL WEIGHT
30" Tall (door)
36" Tall (door)
Drawer
PANEL THICKNESS
All Panels
|
10 Sub-Zero Customer Care 800.222.7820
. Allow for panel thickness when
MAX
45 lb
(20 kg)
60 lb
(27 kg)
75 lb
(34 kg)
75 lb
(34 kg)
MAX
50 lb
(22 kg)
60 lb
(27 kg)
15 lb
(7 kg)
MIN
5 / "
8
Reveals between panels can vary,
CAUTION
When installing a panel thicker than 1"
may be required to prevent damage to the unit and
adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while door is closing.
Finish all sides of custom panels. They will be visible when
the door/drawer is open.
D-style handles are recommended. Door handles must be
located near the edge of the panel opposite the hinge and
should be centered top to bottom. Drawer handles must be located near the top edge of each panel. Stainless steel
tubular and pro handles are avail able through an authorized
Sub-Zero dealer. For local dealer information, visit the find a
showroom section of our website, subzero.com.
(16)
1
/ " reveals are typical.
(3)
8
, the 90° stop
(25)