If You Have A Problem - CleanFreak AI-1260-P Manual De Operación

AVAILABLE ACCESSORIES (OPTIONAL)
MODELS
Carpet tool
Floor and wall brush
Furniture and upholstery
Dust brush
Crevice tool
Water suction accessory
GETTING TO KNOW YOUR VACUUM CLEANER
1. Handle
2. Motor head
3. Cooling air intake
4. Cooling air exhaust (only for wet/dry models)
5. Head clamps
6. Control panel
7. Tank
8. Suction inlet
9. Tank insert
10. Cart
11. Line cord
12. Drain hose (AI-1660-P, AI-1960-P)
13. On/off switch
ASSEMBLY
1. Insert both extremities of the handle on the tubes located in the rear of the cart.
2. Insert the four screws (included) and tighten.
3. Insert the two screws (included) in the mid separators and tighten.

IF YOU HAVE A PROBLEM

PROBLEM
Vacuum does not start.
Low suction.
1 HEAVY DUTY ACCESSORIES
1/2"
AI-1260, AI-1660, AI-1960
14
2
4
6
8
10
POSSIBLE CAUSE
Not firmly plugged in.
Tank full.
Filers are dirty.
Motor head not installed correctly.
Clogged hose.
28.5" Squeegee
NOTE:
The number of accessories varies depending on each model.
1
3
13
5
7
9
FRONT VIEW
Plug in firmly.
Empty tank.
Shake dust off cloth and wash the sponge
Be sure the hood seats properly on the tank.
-3-
Check the snap clamp are closed.
Clean the hose.
SIDE VIEW BACK VIEW
POSSIBLE SOLUTION
11
12