Tabla de contenido
Step 14
Unfold the UPPER BACK (K) and lay both BACKS (K and L) over
å
your unit. The notches in the UPPER BACK (K) should fi t into the
notches in the LOWER BACK (L).
Make equal margins along all four edges of the BACKS (K and L).
å
Push on opposite corners of your unit if needed to make it "square".
Fasten the BACKS (K and L) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
HUTCH UPRIGHT (F).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
These holes must line up over
the HUTCH UPRIGHT (F).
www.sauder.com/services
Notch
K
L
418649
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(49 used in this step)
1N
Page 19
Tabla de contenido
