Control Pads On The Dehumidifier; Control Pads - Keystone KSTAD506PD El Manual Del Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CONTROL PADS ON THE DEHUMIDIFIER

NOTE: The control panel of the unit you purchased may be slightly different according to the
models.
2 2
Filter
Bucket full
indicator light
Pump
1 1
Fig.1

Control pads

When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
Pump Pad
1 1
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is installed
into the unit and the continuous drain hose is removed
from the unit before the pump operation is activated.
When the bucket is full,the pump starts to work.Refer
to the next pages for removing the collected water.
Do not use this operation when the outdoor temperature
is equel to or less than 0 C (32 F).
2 2
Filter Pad
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
3 3
Fan Pad
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
Filter
Full
Pump
7 7
Pump operation
on indicator light
Timer on/off
indicator light
O
O
Clean filter
indicator light
Turbo
Cont.
Auto defrost
On
Off
Timer
5 5
6 6
Power Pad
4 4
Press to turn the dehumidifier on and off.
5 5
7 7
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the
percent value(%).
For damper air, press the
percent value(%).
Use the Up/Down pads to set the Auto
start and Auto stop time from 0.0 to 24.
To run the unit in continuous mode, press the
pad until the display reads 35% RH. Then press
the
continuous operation. To stop continuous operation,
press the
level to resume nominal operation.
4 4
High fan
indicator light
Fan
4 4
Auto defrost operation on
indicator light
: Down/Up Pads
Humidity Set Control Pads
pad and set to a lower
TIMER Set Control Pads
Continuous Operation
pad again until the display reads CO for
and set the desired % RH set point
3 3
Continuous
operation on
indicator light
pad and set a higher

Capítulos

Tabla de contenido
loading

Tabla de contenido