Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
Step 1. Remove 4 screws on the top case.
Attenuator switch
Step 2. Detach the top case from the bottom case.
• If the coaxial cable is wired over the wall from the
ceiling or floor
1. Cut the cable outlet of the frame using a pair of
cutting pliers, etc.
2. Cut the supplied rubber bushing into halves. One
half is suited for the RG-6U cable (smaller internal
diameter) and other half for the RG-11/U cable
(larger internal diameter). Run the cable through
the bushing. (Insert the bushing into the cable entry
hole after cable installation completion.)
Rubber bushing
3. Run the coaxial cable through the cable outlet.
Bottom case
Top case
Cable outlet
• If the coaxial cable is to be drawn directly from the
wall surface
1. Drill a ø20 mm hole.
2. Run the coaxial cable through the hole and the
bottom case as well, and draw it out as shown below.
• If the coaxial cable is installed using a recessed
electrical box (Mounting pitch: 83.5 mm)
Draw out the coaxial cable through the electrical box
and the bottom case.
Note: Be sure to use a pipe thick enough to allow the
wired coaxial cable to be easily inserted.
Step 3. Strip coaxial cable end.
• RG-6/U
13
Jacket
12
3
10
• RG-11/U
13
3
10
Braided shield
ø20
Unit: mm
Braided shield
Unknit braided shields
and bend it back.
Dielectric
Conductor
Braided shield
Conductor
3
Tabla de contenido
