Know Your Band Saw; Adjustments - Craftsman 124.3299 Manual Del Operador

Ocultar thumbs Ver también para 124.3299:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Upper Bandwheel
Door
Switch
Lower Bandwheel
Door
4. TILTING THE TABLE
For bevel cuts, the table tilts 0 through 45 degrees.
A. To tilt the table, loosen the wing nut on the table trunnion, set the
table to the required angle and tighten the wing nut again (See FIG.
10).
FIG. 10
B. It is recommended to verify the correct angle setting using an
angle guide, or by making trial cuts in scrap wood. Adjust the
indicator accordingly by using a phillips head screwdriver.
5. ADJUSTING THE BLADE TENSION
To loosen the tension of the blade, turn the blade tension knob
counterclockwise. To tighten the tension of the blade, turn the
tension knob clockwise (See FIG. 11).
FIG. 11

KNOW YOUR BAND SAW

Door Locking
Knob
Table Insert
Blade Guides
Door Locking
Knob
Wing Nut
Blade Tension
Knob
Blade Tension Knob
Guide Post Adjusting Knob
Guide Post Locking Knob
Miter Gauge
Upper Table Trunnion
Lower Table Trunnion
Table
2" Dust Port

ADJUSTMENTS

6. USING THE QUICK RELEASE LEVER
A. This band saw equipped with a quick release blade tension fea-
ture. It is used to help speed up the removal and installation of the
saw blade.
FIG. 12
B. To operate the quick release and remove tension from the blade,
move the lever from the three o'clock position (ON) to the nine o'clock
position (OFF). Reverse direction to tension the blade (See FIG 12).
7. CHANGING AND ADJUSTING THE SAW BLADE
A. This band saw is factory-equipped with a general-purpose wood
cutting blade, the saw blade is set prior to delivery. To change the
saw blade, begin by removing the table leveling hex socket screw,
washer and nut (See FIG. 13).
6
Blade Quick Release
Blade Tracking
Knob
Motor
OFF
ON
FIG. 13

Capítulos

Tabla de contenido
loading

Tabla de contenido