Software Setup - XYZ Printing da Vinci nano Guida Rapida

Software Setup

Load Filament
Open up XYZmaker and click
01
File > Print > da Vinci Printer.
This will display a print screen that lets you set print
settings and prepare your printer.
02
Click DASHBOARD then click Filament > Load Filament
a
b
c
Follow the on-screen instructions to install the
03
filament.
Take the tip of the filament and insert it into the
04
feeding hole. The printer will start to load the filament
automatically.
XYZmaker is a software that is used to operate the da
Vinci nano and prepare 3D models for printing. Download
XYZmaker from http://xyzptr.com/go2nano and install it
on your computer.
First time installation requires an Internet connection.
＊ For better printing results, we recommend that you calibrate before
printing.
Click File > Open. Import your favorite 3D files. Click
01
on the object to adjust the size you need.
When the object is adjusted, you can start printing.
02
Click File > Print > da Vinci Printer.
When you're done adjusting the print parameters
03
you need, click PREPARE.
After preparing, please check if the object is a complete
04
model. After the confirmation, click PRINT.
•
When the printer starts printing, you can monitor the status by
clicking DASHBOARD.
Note
• The recommended operating temperature is 15
~ 90 ). If the room temperature is above this, please open the
℉
front cover to maintain print quality.
• After the print is finished, the object may be removed with a
scraper.
• When using different types of filament, we recommend changing
the extruder module.
Printing
℃ ~ 32 ℃ (59 ℉
6