EHEIM universal 300 Instrucciones De Uso página 16

English
• Protect the mains socket and mains plug against moisture.
It is recommended to form a drip loop with the mains cable
to prevent any water running along the cable to the mains
socket.
• The electrical data of the pump must match the data of the
power mains. This data is found on the type plate, the packaging and in these
instructions.
For outdoor use (open spaces):
• Only use equipment suitable for outdoor use.
• Extension cables and power distributors must be suitable for outdoor use
(splash-proof).
• Power supply cables must not have a smaller cross-section than rubber hose
lines with the abbreviation H05RN-F3G 0.75. Extension cables must meet the
requirements of DIN VDE 0620.
• The device must be protected by a residual current device with a maximum
rated residual current of 30 mA. If you have any questions or problems, please
contact a qualified electrician.
• Connect the device only to a properly installed protective contact mains soc-
ket.
• Protect the power cable from heat, oil and sharp edges. The connecting cable
must not be walked on if it has been laid in the ground or in gravel without an
empty conduit.
• Only operate the device when there are no persons present in in the water!
4.
Function
The pump can be used both inside and outside the water. It is not self-priming and must therefore be placed below
the water level when operating outside.
• The pump must not run dry.
• Temperature range min +4°C to max 35°C.
EHEIM universal 300 / 600 (⌦ A1):
a b
Motor body Mounting plate
f
Pump cover with sealing ring
cover
EHEIM universal 1200 (⌦ A2):
a b
Motor body Mounting strip
f
Pump cover with sealing ring
k
cover Retaining ring
c
Threaded connection, discharge side
g
Coarse filter
c
Threaded connection, discharge side
g
Coarse filter
l
Orifice plate
h i
Intake grille Threaded connections, intake side
h i
Intake grille Threaded connections, suction side
16
d e
Pump impeller
d e
Pump impeller
Ceramic shaft
j
Sealing
Ceramic shaft
j
Closure