Installation Rules; Power Supply Installation - Vimar ELVOX Videocitofonia 0832/030 Instrucciones Instalador - Manual Do Instalador

0832/300
EN
The instruction manual is downloadable from the site
www.vimar.com
FEATURES
- Timing (cycles) and load:
Terminals: 15/0: 15V a.c. 1.2A continuous + 1A intermittent
30 sec. ON 150 sec. OFF
- P = 50VA supply voltage 230V a.c. (other voltages upon
request) 50-60 Hz
- PRI Protection by PTC
- Class II symbol

POWER SUPPLY INSTALLATION

The power supply must be installed in a dry place away
from direct heat or dust. Ensure easy access for inspection
and maintenance. Secure the unit to the wall with the an-
chor bolts provided or insert it into a rack with a omega DIN
bar. Before connecting the unit use a tester to make sure
that the cables are not broken or short-circuited. For user
safety, the equipment operates at a low voltage and is sep-
arated from the mains by a high-insulation transformer. We
recommend installation of an overload cutout of appropriate
capacity between the mains and the unit.
Warning: Cut off mains supply for 3 minutes to reset
the device after an overloading.

Installation rules

Installation should be carried out by qualified personnel
in compliance with the current regulations regarding the
installation of electrical equipment in the country where the
products are installed.
Ensure clearance around the appliance so there is sufficient
ventilation.
There must be no dripping or splashes of water on the appliance.
WARNING: To prevent injury, the appliance must be secured to
the wall as described in the installation instructions.
Above the power supply there must be a bipolar circuit breaker
that is easily accessible with a contact gap of at least 3 mm.
Conformity
LV directive
EMC directive
Standards EN 60065, EN 61000-6-1, EN 61000-6-3.
WEEE - Information for users
If the crossed-out bin symbol appears on the
equipment or packaging, this means the product
must not be included with other general waste at
the end of its working life. The user must take the worn
product to a sorted waste center, or return it to the retailer
when purchasing a new one. Products for disposal can
be consigned free of charge (without any new purchase
obligation) to retailers with a sales area of at least 400m
if they measure less than 25cm. An efficient sorted waste
collection for the environmentally friendly disposal of the
used device, or its subsequent recycling, helps avoid the
potential negative effects on the environment and people's
health, and encourages the re-use and/or recycling of the
construction materials.
Product is according to CE mark and directives:
- EC Directives 2004/108/EC and following norms.
- EC Directives 2006/95/EC (73/23/CEE) and fol-
lowing norms.
Power supplies constitute SELV sources in compliance
with the requirements stipulated in Article 411.1.2.2 of CEI
standard 64-8 (ed. 2012).
Production is subject to costant surveillance:
D V E
,
2
3