Tristar AC-5420 Manual De Usuario página 5

Emptying the Drainage Tank
1. Lightly press on the sides of the tank with both hands and pull the tank
out gently.
2. Discard the collected water
NOTE
• Do not remove the float from the water tank. The water full sensor will
no longer be able to detect the water level correctly without the float
and water may leak from the water tank.
• If the drainage tank is dirty, wash it with cold or lukewarm water. Do
not use detergent, scouring pads, chemically treated dust cloths,
gasoline, benzene, thinner, or other solvents, as these can scratch and
damage the tank and cause water leakage.
•
When replacing the drainage tank, press the tank firmly into place
with both hands. If the tank is not positioned properly, the "TANK FULL"
sensor will be activated, and the dehumidifier will not operate.
Continuous Water Drainage
The unit features a continuous drainage port .Using a plastic pipe (with an
inner diameter of 10mm). Take out the water tank and put the drainpipe
over the water outlet of the unit. Put the water tank back in place and
guide the drainpipe through the hole of the water tank. The water in the
drainage tank can be continuously drained out from the continuous port
on the unit.
Dehumidifier
EN
5