Ferm PGM1008 Traducción Del Manual Original página 7

• Remove the air filter cover (16).
• Remove filter element and wash well in
solvent.
• Pour a small amount of oil onto the filter
element and gently squeeze out any excess
oil.
• Replace the filter element and air filter cover.
• Be sure the filter cover seals properly all
around.
Do not run the engine without the air filter
element in place.
Never place a wet filter (with solvent) on
the machine.
Fuel tap
• To remove the fuel tap filter, simply undo the
cup at the bottom of the fuel tank
• Use a small spanner to remove the tap
• Clean and wash out the filter and cup, and
replace.
Troubleshooting
Basic checks
• Make sure you have plenty of fuel
• Make sure the fuel tap is on
• Make sure the engine-switch is on
• Make sure the oil level is correct
• The generator has an oil sensor. When the oil
level is too low, the generator will not be able to
start.
• Remove spark plug, connect spark plug lead
and earth it to the generator. Pull starter cord
gently and look for a spark. If there is no spark,
replace spark plug.
Spark plug is OK, but engine still won't start
• Check fuel tap filter is clean
• Check fuel line is clear
• Check carburetor is not clogged
engine will not start
• Clean or replace spark plug
• Check ignition system – if faulty, contact your
service centre
• Check compression – if low, contact your
service centre
• Check for loose cylinder head – tighten bolts
• Check for damaged cylinder head gasket –
replace if necessary
cleaning
Clean the housing regularly with a soft cloth,
Ferm
preferably every time it is used. Keep the air vents
free of dust and dirt.
Remove stubborn dirt with a soft rag moistened in
soapy water. Do not use any solvents such as
petrol, alcohol, ammonia, etc. as such substances
can damage the plastic parts.
Storage (long term)
• Drain fuel tank, fuel tap, carburetor bowl and
carburetor
• Pour 1 cup of engine oil into the fuel tank and
shake the generator to spread the oil around
the tank. Drain excess oil.
• Remove spark plug and pour in 1 spoonful of
engine oil, pull the starter cord several times
with the starter switch OFF. Replace spark
plug.
• Pull on the starter cord until you feel
compression and stop.
• Clean the generators exterior and coat with
rust inhibitor.
• Place the generator on flat ground and cover
with a clean dry cloth.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the warranty
card. In the back of this manual you find an
exploded view showing the parts that can be
ordered.
environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
Warranty
Read the terms of warranty on the separate
warranty card which is enclosed.
EN
7