Cleaning And Care; Troubleshooting - oneConcept 10030852 Manual Del Usuario

• Please shut off the power and pull out the plug before cleaning of the appliance.
• Clean the appliance until it cools down completely.
• To remove dirt, please select litmusless detergent.
• After removing dirt, please use neat wet cloth to clean the unit.
• Don not clean by water directly, water gets inside may cause malfunction.
• Keep the ceramic plate and pan clean before cook, otherwise, dirt after charring is very
difficult to clean and the plate may get discoloration.
• You may clean air vent/air entry's dirt by vacuum cleaner to suck up, if there is dirt with
oil, add a little litmusless detergent with toothbrush to clean.
• Don't use caustic impregnates to clean. It may damage the cooker by chemical reaction.
Do not use benzine, scrubbing brush or polishing powder to clean the induction cooker.
No Indicator light when
Power "on".
If there is "buzz" noise, and
the "on/off " light flash, no
heating.
Appliance suddenly stops
heating During operation.
No response for the key.
The led display shows "E0"
or such code together with
alarm.
Please do not open and repair the unit yourself avoid getting hurt and other risks. If you fail
to identity the problem, contact the after-sales service without delay.
12

Cleaning and Care

Troubleshooting

Cable/terminal block is loose.
Broken circuit or blown fuse.
Power supply stopped.
Please check if the pot is available.
If the pot is in the centre of the ceramic plate.
Air entrance or outlet blocked.
Over-heating protection activated.
Please check if the temperature around is too high.
If the working time over defaulted working time, or the
timer finish
Please check the plug is in right place.
Please check if the voltage is too low or too high. Cut off
the power and restart after several minutes.
Please check if the temperature is too high.