Utilitech Pro SE1048-BP2-02LF0-U Manual Del Usario página 4

INSTALLATION INSTRUCTIONS FOR ROUND SURFACE MOUNT ELECTRICAL BOXES
properly grounded. If unfamiliar with the methods of properly
electrical box is made of plastic and/or has a green or bare
the electrical box ground wire should be connected together using the wire nut (DD). If the electrical box is made of metal
ground wire to the mounting strap marked "GND" using
the green grounding screw. Push-in connectors (HH) are
connection. Insert the black lead from the electrical box into
the black wire push-in connector (HH). Repeat with the white
leads. Push the excess wires back into the electrical box.
Hardware Used
DD
Wire Nut
HH
Push-in Connector
4. If the LED head is loose and will not hold its position,
tighten the screws that surround the ball joint. NOTE: This
box.
5. Position the wall plate over the mounting strap so the
center hole of the wall plate aligns with the center hole in
the mounting strap. While holding the wall plate in place, put
the long machine screw (EE) through the center hole of the
wall plate and mounting strap. Tighten the screw properly to
secure the wall plate onto the electrical box. NOTE: Make
sure the gasket (GG) properly seals the gap between the
wall plate and the electrical box to prevent water seepage
into the electrical box.
Hardware Used
Long
EE
Machine Screw
head with the adjustment controls and drain holes
facing downward to prevent water damage. The
position of the sensor head should not exceed 45
degrees from horizontal.
3
x 1
x 2
4
5
x 1
6
45°
45°
4
HH
EE
45°
DD
45°