König Electronic CMP-UPS500SP Manual De Uso página 3

Installation
Inspection
Inspect the UPS upon receipt. The packaging is recyclable. Save it for re-use or
dispose of it properly.
Placement
Install the UPS in a protected area with adequate airflow, and away from direct sunlight
and excessive dust. Do not operate the UPS where the temperature and humidity is
outside the specified limits in the Specifications Table.
Connect to Utility
Connect the AC input power connector to utility power to power up the UPS.
Charge the battery The battery in the UPS will lose some power during shipping and storage. It will
recharge completely after approximately 8 hours of normal operation. Do not expect
full battery runtime during this initial recharge period.
Connect the loads
Plug the loads into the output connectors on the rear of the UPS.
Caution: Never connect a laser printer or plotter to the UPS with other computer
equipment. A laser printer or plotter periodically draws significantly more power than
when idle, and may overload the UPS.
Operation
Switch On
With the UPS plugged in, press and hold the POWER button over 4 seconds until you
hear one beep sound to switch the UPS on. The UPS will perform a self-test each time
it's switched on.
Switch Off
By pressing and holding the POWER button over 4 seconds until you hear one beep
sound.
Self-Test
In normal utility power, push the POWER button less than 1 second and UPS performs
a self-test on the battery capacity. During the self-test, the UPS operates in backup
mode, the BATTERY and FAULT icon stay on.
Backup(slow alarm)
When in Backup mode, the BATTERY and FAULT icon illuminates and the UPS emit a
beep every four seconds. The alarms stops when the UPS returns to the utility power
operation. Press the POWER button to stop the beep.
Low Battery(rapid alarm)
In Backup mode, when the battery energy runs low, the UPS beeps rapidly until the
UPS shuts down from battery exhaustion or return to utility power operation.
Overload (continuous alarm)
When the UPS is overloaded, the OVERLOAD icon illuminates and the UPS emits
continuous alarm for 30 seconds to warn about an overload status. Disconnect
nonessential load equipment from the UPS to eliminate the overload.
3