Technical Information - IntesisHome PA-AW-WIFI-1 Guia De Instalacion

IntesisHome PA-AW-WIFI-1
GB
®
4.4 Placement
IntesisHome device needs to be placed close to the Control Panel, when there is a Monobloc system and
®
next to the Indoor Unit, when there is a Bibloc system (see Figure 5).
Important: Avoid placing
the device next to metal
surfaces.
Recommendations:
1. Use the top hole in the back of the IntesisHome
unit or the Control Panel (See Figure 1).
2. In order to place the device, use the holes in the back of the device to screw it. Double side tape
can also be used to fix it. Please remember to leave enough space for the connected cables (See
Figure 1).
3. Fix the IntesisHome
Point or router). If you have coverage problems after installation, please visit the connectivity
support section in our site at www.intesishome.com/support/connectivity

5. Technical information

In order to obtain a complete and technical description of the device, please see the document at http://
www.intesishome.com/docs/PA-AW-WIFI-1-Technical-Info-eng.pdf
6. FAQ and support
For any question or problem related with the product or the installation procedure, please visit our support
center at www.intesishome.com/support .
6
Important: When possible, try to check Wi-Fi coverage
in the installation location. Good Wi-Fi level is strongly
recommended.
device preferably as close as possible from the Wi-Fi signal source (Access
®
Bibloc
example
Figure 5.- IntesisHome
device to insert cables coming from the indoor
®
Monobloc
example
Device and Aquarea placement
®
INSTALLATION GUIDE