Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SOFTWARE DOWNLOAD:
www.bresser.de/download/7004040
The software allows you to save and display your
recorded data. Install the software by following
the setup instructions and then start the software.
Now connect the device via the micro USB cable to
your computer and press the power on/off button.
In the Software, click on the USB icon [
establish the connection.
When you click on „Set Time" the current time will
automatically sync and set on the device.
RECORDING AND RECEIVING DATA
Click on „Set Param" to enter the settings menu
and set parameters as appropriate.
Here you can choose two ways to record the data:
Method 1: Immediately
Method 2: Manual
24
Method 1: Immediately
This method is used when you record data while the
device is connected to your computer. Choose the
number of records and set an Interval. Then choose
„Immediately" and click on „OK" to begin recording.
„REC" flashes on the display. The flashing frequency
is the same as the recording interval, indicating that
measurement of the instrument is carried out. The
] to
data received can only be checked once the recor-
ding is done. Wait until the recording is finished or
click on „Stop Recording" and then click on „Data
Download" to save the recorded data. You can now
open the saved data file to see your recordings.
Method 2: Manual
This method allows you to take the device to a
location, record the data there, and then go back
to your computer to download the recorded data
from the device.
First connect the device to a computer and esta-
blish the connection. Then click on „Set Param"
Tabla de contenido
