Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"xl- 1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE
SHOWN ACTUAL
SIZE
©
©
Nut 5/16"-18
LockWasher
5/f6"
Carriage
Bolt
5/16"-18x2*f/2"
Header Wall
2x4
Finished Ceiling
Horizontal
and vertical
reinforcement
is needed for
doors
(fiberglass,
aluminum,
steel,
door with glass panel, etc.).
(Not Provided)
For a door with no exposed framing,
or for the optional installation,
use
5/16"x1-f/2"
lag screws (Not Provided)
to fasten door bracket.
24
Capítulos
Tabla de contenido
