Sharp PN-V701 Manual De Instalación página 11

nMode setting
When the monitor is turned on for the first time after being
shipped from the factory, the mode setting screen will be
displayed.
(1) Press the or button to select YES or NO.
(2) Press the ENTER button.
YES:
• OPERATION MODE is set to MODE1.
• OFF IF NO OPERATION is set to ON, and POWER
SAVE MODE is set to ON. (These settings cannot be
changed.)
• If there is no operation for 4 hours or more, the monitor
automatically enters standby mode.
• Compared to when POWER SAVE MODE is set to OFF,
the current consumption is reduced while the monitor
is in standby mode, but the startup time from standby
mode becomes longer.
• While the monitor is in standby mode, control via LAN
will be disabled.
• While the monitor is in standby mode, only certain
RS-232C commands can be used.
• While the monitor is in standby mode, the remote
control unit cannot be used to operate the display of the
secondary unit.
NO:
• OPERATION MODE is set to MODE2.
• OFF IF NO OPERATION is set to OFF, and POWER
SAVE MODE is set to OFF.
(These settings can be changed.)
• Compared to when POWER SAVE MODE is set to ON,
the startup time from standby mode is reduced, but more
power will be consumed in standby mode.
Even after being set, changes can be made using
OPERATION MODE, located in MONITOR menu. (See
OPERATION MANUAL.)
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
01 / 01 / 20
1. Press the or button to select the date and time, and
press the or button to change the numerical values.
2. Press the ENTER button.
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
• Set the date in "Day/Month/Year" order.
• Set the time on a 24-hour basis.
• The clock is maintained by the internal battery.
• If you already set the time but the date/time setting screen
appears when the power is turned on, the internal battery
may be exhausted. Please contact an authorized SHARP
servicing dealer or service center for assistance with
battery replacement.
• Estimated service life of the internal battery: About 5 years
(depending on monitor operation)
• The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before its
expected operation life.
Turning Power On/Off
: :
17 00 : 00
OK:[ENTER] CANCEL:[RETURN]
9
E